I just learned how to build a small workbench computer. It consists of a Raspberry Pi 4, 7” Touchscreen display, a Keyestudio 4 Channel Relay, a GPIO Breakout Board, Raspberry Pi Camera, DHT22 Sensor.
The Raspberry Pi 4 is attached to the back of the touchscreen display. I then have the GPIO Breakout Board stacked on top of the Raspberry Pi. The Keyestudio Relay board is then stacked on top of the GPIO Breakout Board.
The touchscreen display with the stacked boards are enclosed in a case made out of cardboard. On top of this case sits the camera. The back of the case is open to allow multiple wires to extend to other devices that the workbench computer will control.
The homemade case measure 10” wide, 7” high and 3 ½” deep.
The case is temporary because it’s only made out of cardboard. I am looking to purchase a case with similar dimensions made out of plastic or wood. I have seen many cases but none of them are deep enough for my boards or they don’t have openings in the back to allow for all of the wires.
I have searched and searched all over the Internet but have yet to find what I am looking for.
The instructor of the course had one made by one of his students which is perfect. The only problem, it was made about 6 years ago and he has not been able to track down the student.
Does anyone know where I might be able to find a case like the one that I mentioned.
I've attached photos of what I am looking for.
The Raspberry Pi 4 is attached to the back of the touchscreen display. I then have the GPIO Breakout Board stacked on top of the Raspberry Pi. The Keyestudio Relay board is then stacked on top of the GPIO Breakout Board.
The touchscreen display with the stacked boards are enclosed in a case made out of cardboard. On top of this case sits the camera. The back of the case is open to allow multiple wires to extend to other devices that the workbench computer will control.
The homemade case measure 10” wide, 7” high and 3 ½” deep.
The case is temporary because it’s only made out of cardboard. I am looking to purchase a case with similar dimensions made out of plastic or wood. I have seen many cases but none of them are deep enough for my boards or they don’t have openings in the back to allow for all of the wires.
I have searched and searched all over the Internet but have yet to find what I am looking for.
The instructor of the course had one made by one of his students which is perfect. The only problem, it was made about 6 years ago and he has not been able to track down the student.
Does anyone know where I might be able to find a case like the one that I mentioned.
I've attached photos of what I am looking for.
Statistics: Posted by hchernick — Fri Oct 25, 2024 10:42 pm